Description

Tables of fundamental tolerances in grades 6 to 16, fundamental deviations and limits for 14 qualities of shaft and hole in inch and metric for diameters 19.69 to 125 in (500 mm to 3150 mm). Review of manufacturing problems and measuring large workpieces, information on practical effect of errors on tolerances and fits, description of technique of matched fits. Imperial units only.

Cross References:
BS 1916-1
BS 1916-2

The metric requirements have been replaced by BS 4500:Part 1:1969.

Incorporates the following:
AMD 278 published 15 July 1969
AMD 3730 published 30 September 1981